Engine Lathe

Specifications:
18" Swing, 11" Over Carriage, 60" Long

Parts Produced:
  • Pistons
  • Drive shafts
  • Pusher Pins
  • KO Intermediate Pins
  • Bushings
  • Quill Cases

 

Heavy Duty Knee Mill

Specifications:
Table L: 60" W 15 1/2" H: 18"
Used for : rough and finish milling to size before heat treating, slotting, larger key ways, holding pieces parallel and square, rough drill and bore.

Parts Produced:
  • Keys
  • Wedge Blocks
  • Large Hexes for Bolts
  • Liners (Bronze & Steel)
  • Quill Cases

 

Radial Drill

Specification:
Base: L: 50" W: 38" H: 44"
Small Table: L: 26 1/2" W: 18"
Used for: Drilling, tapping, and honing.

Parts Produced:
  • Plates Blocks
  • Wedge Blocks

 

OD/ID Universal Grinder

Specification:
Capacity 12" O.D. 38" Length
Used for: Grinding Straight, agles, holding Micro Finishes up to 16 micro, and small I.D. Bores

Parts Produced:
  • Pistons
  • Piston Rods
  • Transfer Shafts
  • KO Master Pins

 

Bridgeport Mill

Specification:
Capacity Table L:48" W: 9" H:15"
Used for: mill, drill, slot, angle or straight . Can hold close tolerances.

Parts Produced:
  • Connection Pins (APT)
  • Male & Female
  • Upper & Lower Plates
  • Key Ways

 

Surface Grinder

Specification:
Table L: 39" W 19" H:18"

Used for:
  • Grind Angles with Fixturing
  • Grind Flat and Parallel to
  • Close Tolerances and
  • Micro Finish